BMW Luxury Touring Community banner

1 - 6 of 6 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
I'm installing an autoswitch on my 2001 model.
The only problem i have, is where to get to the turn cancel signal wire.
I opened the handle bar but still can't see what cable to use.

I would prefer to connect the cable in the relaisbox under the fuel tank.
I know which relais it is, but again i'm not sure witch cable to use.
Anyone who did this before?

I searched the forum, but couldn't find the answer yet...
 

·
Wrencher Extraordinaire
2005 K1200LT
Joined
·
14,410 Posts
It is a Brown/White wire down at the relay box. That wire get a ground applied when you hit the turn signal cancel switch.
 

·
Registered
Joined
·
23 Posts
Discussion Starter #4
It works :dance:

I'm curious if it's possible to change the colors of the led.

Green if NOT active, Red if active.. instead of Red if not active and green when active.

Thanks a lot!
 

·
Premium Member
Joined
·
4,886 Posts
Of course, just desolder the LEDs and swap their positions. You can likely add additional LEDs to the circuit and place them where you want, in whatever (available) color you want.
 
1 - 6 of 6 Posts
Top