Joined
·
237 Posts
I'm installing PIAA lights (pic 1) - older model given to me by a friend, so don't know what model PIAA they are - I am including several pics, though.
Basically, I have the switch line, positive and negative lines, and a small (20ga?) white wire (pic 2). I'm not sure where this one goes, but I think it came off a tap to a low beam positive as a sensor: is this correct?
If so, can I tie it to the positive on the parking light (pic 3)? If so, which one of the wires is the positive? Pic 4 shows where the light I'm talking about goes in the back of the headlight housing (bottom left of center) - Pic 5 is the back of the light, showing the wires.
Many thanks in advance!
Basically, I have the switch line, positive and negative lines, and a small (20ga?) white wire (pic 2). I'm not sure where this one goes, but I think it came off a tap to a low beam positive as a sensor: is this correct?
If so, can I tie it to the positive on the parking light (pic 3)? If so, which one of the wires is the positive? Pic 4 shows where the light I'm talking about goes in the back of the headlight housing (bottom left of center) - Pic 5 is the back of the light, showing the wires.
Many thanks in advance!
Attachments
-
417 KB Views: 111
-
484.7 KB Views: 110
-
369.4 KB Views: 112
-
468.5 KB Views: 76
-
345.3 KB Views: 91