BMW Luxury Touring Community banner

1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1
Removed my rider, pillion seat and pillion backrest months ago and then put them back on today. Just not sure where these go. The only other 4 items are the four screws that hold the backrest on to the trunk but they don't seem to fit anywhere. Any ideas?

 

·
Wrencher Extraordinaire
2005 K1200LT
Joined
·
14,411 Posts
Those go on either side of the two mount holes at the front to protect the plastic from wear from the mounting bolts. They should fit into each other (2 per hole). Here they are under the leg of a BakUp backrest and spacer. I like to put them in with some Goop just to hold them in (I did Goop the spacers for the backrest as well) as they tend to fall out when you remove the bolt..
 

Attachments

1 - 3 of 3 Posts
Top