[ebiss9]

I took these without a flash so they are a little blurry but you can get the general idea. Bottom scale on steel rule is 10ths.

 

[ebiss9]

Wished I could tell what was used to grind this but my machinist son-in-law did it for me. I waited almost a year to get it back, (he's quite a procrastinator). But I do remember him saying it was rather difficult due to the hardness of the material..........Rob

 

[ebiss9]

Hey Guys, I ran across this drawing today which may help in your quest to build the socket. I don't know where it came from but may have been posted previously by another member. Hope it’s legible enough to view. All measurements are in inches………….Rob