BMW Luxury Touring Community banner

1 - 7 of 7 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
Been wiring the dauntless hitch for my unigo, needed to run a lead to the battery, figure no problem. I pulled the knob to release the seat and nothing - the knob remain out even when released. The seat didn't release at all - it's stuck in place - tight. Any words of wisdom or suggestions will be greatly appreciated.

Thanks - JIm
 

·
Registered
Joined
·
46 Posts
Discussion Starter #3
great tip - and it's time for me to ante up the $$$

Raffy - no small fingers in this household - but a nice wide flat bladed screw driver work just fine.

Thanks.

An now it's time to pay the piper and become a supporting member

Jim
 

·
Registered
Joined
·
6,285 Posts
jsralston said:
Raffy - no small fingers in this household - but a nice wide flat bladed screw driver work just fine.

Thanks.

An now it's time to pay the piper and become a supporting member

Jim
Well, now since you paid up :bmw: make sure the two screws holding the H shaped bracket on the back of the seat are snugged up so it doesn't happen again! ;) (usually what happens...)
 
1 - 7 of 7 Posts
Top