BMW Luxury Touring Community banner

1 - 6 of 6 Posts

·
Enjoy The Ride
Joined
·
3,989 Posts
Discussion Starter #1
I have now sent the last sockets for the orders I had from this summer.

I have 10 30mm & 11 14mm sockets left for sale plus 5 12mm long hex wrenches.

The sockets are $35 each & the 12mm hex wrenches are $10 each.

Shipping cost to all 50 states with Insurance is $7.50

This will be my last batch of sockets for awhile.

Paypal or check is ok for payment.

PM me for Paypal info & your shipping address.
 

Attachments

·
Registered
Joined
·
659 Posts
They're too darned pretty to use! Seriously, nice job. I did my weep hole when I had the LT and it certainly gave me great peace of mind knowing the clutch was being monitored/protected somewhat.
 

·
Enjoy The Ride
Joined
·
3,989 Posts
Discussion Starter #3
I am out of the 12mm long hex wrenches. I have three 30mm cut out sockets & six 14mm reinforced pivot pin sockets left.

One socket $35 + 7.50 for shipping = $42.50

Both sockets $70 + 7.50 for shipping = $77.50
 

·
Enjoy The Ride
Joined
·
3,989 Posts
Discussion Starter #5
Ron02LT said:
What are they used for ?
The 30mm cut out socket is required to install the Final Drive & the Swing Arm. You must have the 30mm cut out socket to hold the pre-load on the pivot pins while you torque the jam nut.

The reinforced 14mm socket is not required to remove the Swing Arm pivot pins but many of us have broke 14mm sockets removing the pivot pins. When the socket breaks the 14mm hex on the pivot pin rounds out. I reinforce a 14mm impact socket so it can't expand or break.

Hope this helps, Dave
 
1 - 6 of 6 Posts
Top