|Topic Review (Newest First)|
|Aug 22nd, 2007 5:36 am|
Vitesse & James,
Thanks for the response. Some good info there. My gut feeling is to go to the CB plug as everyting I need is there, but then again... If only there was a standard between the radio manufacturers for the mic/spkr sockets and the associated PTT function - in a perfect world (sigh).
73 for now
|Aug 21st, 2007 8:52 pm|
At the link below, I recently posted a schematic for a Kenwood speaker-mic that goes into a Kenwood HT.
A direct male-to-male in this same configuration works with the 2.5mm and 3.5mm jacks on the front of the factory intercom. (Note -- the speaker mic schematic has many features you don't seek and that can be ignored in the context of your question -- you just need audio.)
On an LT, PTT is available via the cable/connector under the left side handlebar cover. (Referring to my model year, 2006; I assume many others, but can't speak for all years or any other model as I've never researched it beyond my needs.) A BMW acce$$ory switch is employed with this. Be prepared to bring money (or make home-brew alternate arrangements you're happy with there), but, I'll observe this ... the factory switch sure is clean and easy to install and use day-to-day. Besides, if you own an LT, what's another 82USD, right? (Note - the switch may be configured normally open or normally closed. NO is typical/customary in this type of service. Looks quite easy to change should you get it backwards for any reason.)
Some have also wired into the CB jack underneath the Tupperware for all functions you've asked about. Never tried it, but, I've seen a schematic in the "file" section to pursue that approach as given here:
Conclusion ... the mic and speaker interface to the front intercom jacks as shown in the speaker-mic schematic. PTT may be accomplished more than one way; I use the cable underneath the left side handlebar cover in concert with the available "factory" switch.
Please verify all of this before permanent commitment to the given pin-out or using any of this information. Hope this offers you a launching point to access audio and switching so you can get your Yaesu up and running.
|Aug 21st, 2007 8:22 pm|
It should give you what you need if you look at the Voice II end of the cable
|Aug 21st, 2007 4:28 pm|
BC Voice II & Yaesu VX7 Handie
My LT is equipped with the BC Voice II intercom unit. I am having a PTT fittted at the next service so that i may use the FRS facility to connect to my Yaesu VX7-R Handie. I intend to install a 6m/2m/70cm whip on a CB mount in the future, but the first step is to get the raio interfaced to the intercom system.
I canot seem to find the required information that will allow me to constructthe intercafe cable necessary, can anyone help please? What I needto know is what the 3.5mm and 2.5mm sockets do and how the PTT interacts with them Then I can construct the right cable.
73 for now
Simon aka M0BOX