Centerstand clearance????

[motorman587]

Is there a way to get more clearance with the centerstand. Can the centerstand, when in the up position, where it rest, be bent to allow more clearance???

[mjordans2000]

I assume you have a pre power stand. If you look where the stand rests against the frame you'll see rubber bumpers. You can trim these a bit which will give you more clearance (careful not to cut too much or it will hit the muffler. I would not try bending the stand.

[grifscoots]

Or just grind em them down the way you do.... slow, fast, whatever as long as there's a curve. I seen you do it!

[motorman587]

Muffler is no problem, I have the Remus Exhaust, so I have a lot of room. I have been griding them down. I also have bent the centerstand, which you stand on to put it on the centerstand.