PIAA PL5FB pin wiring diagram

[DanDiver]

I purchased a used PIAA 1100X Light set ( installed with the EZ Bracket) and some of the wiring was modified by the previous owner. The wiring diagram with the kit shows a few thing not included in what I received, and in order to back out the correct wires for my relay, switch and power connections, It would be helpful if I knew where the wires for each pin connection from the PL5FB rely were supposed to be connected.

Looking at the relay, where there are wires connected, there are two pins on the left and two on the right. Wires are attached, but I'm not positive as to what they should be connected to. Previous owner did some modifications, so I hesitate to focus on the black/white/thin red and thick red wire normal connections.

I can't seem to find this info on the PIAA site, but my search skills could be improved. Hope this isn't too confusing.

[DanDiver]

What I just received from PIAA:
~~~~~~~~~~~~~~~~~~~~~~
Our wiring harness comes complete from Japan and we do not have anything showing were the individual wires hook up to in the loop of the harness. We just show where to hook up the connector wires that are loose from the factory.

Thanks
A A
PIAA Customer Service

Guess I'm back to ground zero...... any suggestions?

[cfell]

Dan..
The circuits are not that hard to figure out..usually.

Do you have pics of the wiring? Maybe we could "short" it out for you... er.. "sort it out".. =)

[DanDiver]

Dan..
The circuits are not that hard to figure out..usually.

Do you have pics of the wiring? Maybe we could "short" it out for you... er.. "sort it out".. =)


The previous owner rewired the relay so the wirs out of it don't match PIAA's diagram. I'm off to Boot-Camp and as soon as I get back I'll take a few pictures of what I have. I might just hook it up away from the biks and then with a meter, back it all in.

[DanDiver]

Not a lot to go on. Any suggestions would be appreciated. I might just have to order another harness from PIAA as they too don't know where individual pins go! I'm heading out in a while for an overnight ride and will be away from the internet for a while... What a beautiful day in Florida as our season begins........ YaHooooooooo

[sperra]

Dan starting at 2oclk ground, 4oclk from switch /trigger power,8oclk power from batt, 10oclk power to lights. hope this helps

[DanDiver]

Thanks - That is EXACTLY what I was looking for. Now it's time to get the bike undressed.....