Starcomm 1 wiring into stock harnes

[scoobydoo]

I have seen the pictures before,,,,I just cannot seem to find it now. I would like to remove the inside liner to gain access to the speakers...which Torx screws do i remove.

I am wiring the MUS-3 cable into the bike, but I am not in favour of cutting the stock wiring (but I will )

From what I can tell, it works much the same as the autocomm, would like to wire in a switch to turn the rear spekers on/off when required. I know some have done this. Do you use it? where did you mount the switch?

I did visit the HOW, unfortunatly the seach to disasemble the top case did not turn up anything.

[scoobydoo]

when looking at the stock plug under the seat - would anyone know which colour wire relates to the rear speakers?

thanks

[messenger13]

when looking at the stock plug under the seat - would anyone know which colour wire relates to the rear speakers?

thanks
Yellow/Blue = Left +
Yellow = Left -
Blue/Red = Right +
Blue/Grey = Right -


HTH

[scoobydoo]

Thanks that helps to get me started....