Unigo Measurement?

[oknplm]

I recently purchased a Uni-go that came off a Goldwing. Just received the body back from the painter and before I re-assemble. I have one question to ask.

For those of you that have a Uni-go, what is the "factory height setting" of the trailer tongue on the front trailer mounting panel, for the LT setup?

Can anyone provide the measurement of the distance between the front bottom edge of the trailer frame and the bottom edge of the tongue-mounting base?

My only other option is to pick a hole position, from what is available on the mounting panel, load the Uni-go, put my wife and I on the LT and then hope I picked the right trailer height on this first attempt. Not to high or low fully loaded.


May we never find the end of the road!

Perry Ridgway

oknplm

[Tbird]

I'm sitting here ready to measure...but can't picture in my mind where your talking about. Maybe you can help me figure it out...so I can give you that measurement.

[Tbird]

Is it one of these distances ( look at the attached picture)?

[oknplm]

TBird

It was ""B".

Thanks for looking


Is it one of these distances ( look at the attached picture)?

[bowlesj]

Is it one of these distances ( look at the attached picture)?

Hey Tom, those front casters are cool. Any trouble with speed bumps or the like?

[Tbird]

Yes...the time I forgot to take them off before departing. They are not for
traveling! Held on with wing nuts...easy to remove. Just meant for use during
storage and like rolling luggage when on the road. It sleeps inside the hotel
room with me. We even had a bell hop bring it UP to the room one time in Las
Vegas.